The Sicma Wood Chipper EC100 has  manual feed and it's transmission is run by a system of pulleys and belts (no direct drive) and therefore no clutch is required. Driveline (EUROCARDAN series 4) is instead equiped with a freewheel for absorbing inactivity when disengaged. The flywheel turns at 1620 r.p.m., and the hardened steel cutting blades are staggered (not aligned) for a better use of cutting power. The hopper is more inclined and allows a more efficient gravity feeding system. Through a lever, the reinforced discharge tube can be turned 360 degrees, in order to set the direction of shredded material. With a height of 1920 mm (76"), loading material into a bin or loader is easy. The flywheel has a pulley shaft. There are no welds on the Eco Chipper 100 for a seamless finish. This reduces vibration and noise. Eco Chipper 100 can be run with a minimum of 20 HP, absorbing less power than the competitive products.

Standard Equipment: 

  • Cat I 3 pt hitch
  • 540 rpm PTO
  • transmission is a system of pulleys & belts
  • 4 hardened steel cutting blades are staggered
  • reinforced discharge tube can be turned by 360ĚŠ
  • 5.75" x 8.25" feeding opening
  • 76" high tube with deflector
  • 28" x 28" hopper
  • able to shred up to 4" diameter trees
EC100 608 lbs 20 4" diameter 28" x 28" 4 4" diameter, 110 lbs, 1620 r.p.m. 540 r.p.m.


Site Map | Login | Powered By: Techweavers Inc.